Operating Instructions
Page 35/60
5. Now enter the desired values here.
“Position"
describes the location where
the CCM-S will be used.
With
"Scale limit"
the limit value for wear
can be set. The limit is set to 3% by default.
With
"Logging time elongation"
you can
set the time interval in which the elongation
value of the chain should be stored. Time in
0.1h.
Confirm your entries with "OK".
6. All data of the previous chain are deleted
with "Yes"!
7. Please log out again. To do this, click on
the registration symbol again.
Symbol
Meaning
NOTE
A permanent visualization via your PC is not intended.
NOTE
Due to the length tolerances of the chain, an initial elongation value of up to +0.15% can
be displayed when testing a new chain, or the value can even be in the minus range.
7.5 Reading/ Saving / Resetting the Error Log
To view the error log, the following conditions must be met:
_
The CCM-S must be connected to the PC ready for operation via the USB cable
_
An error must be logged (otherwise the button is grayed out)
_
You must be logged on as an administrator in the iwis CCM Monitor software
If these conditions apply, proceed as follows:
