Operating Instructions
Page 16/60
Risk
Damage to property as a result of incorrect installation
Warning symbol
Possible consequences of the
incorrect action
Damage to property, measurement errors or jamming of the chain
Measure to mitigate risk
Gap of at least 0.5 m to the sprocket; installation location as free of
vibrations as possible
The CCM can be used in the load run or slack span!
•
The CCM-S should preferably be used in the load span.
•
There is a elongation component in the load strand due to the force that does not exist in the lostrum;
this elongation component makes up to 0.25%!
•
The CCM-S is not allowed to be used as chain deflection or chain tensioner!
•
The chain may only be detected in the CCM-S guided on both sides; the chain is best calmed down by
the guidance on both sides!
•
In addition, the CCM can be connected flexibly (elastically) in the slack span so that the CCM can
absorb chain movements - thereby protecting the guiding track!
•
All speed changes, delay effects etc., which always affect all chain links, are always neutralized by the
two chain links in relation to each other, which means that we act independently of these effects. Only
so-called micro-oscillations within a measurement have an influence on the measuring result!
The maximum cantilevered chain length before and after the CCM must be chosen in such a way that only a
minimal weight load is applied to the CCM. If necessary, the weight of the chain must be intercepted by e.g.
sprockets or guides!
Symbol
Meaning
NOTE
All the risks associated with the product that have been identified have been recorded in the
form of a risk analysis/FMEA!
