REL0.2
Page 40 of 110
iWave Systems Technologies Pvt. Ltd.
Zynq Ult MPSoC (ZU11/17/19EG) SOM DevKit Hardware User Guide
2.5.1.3
SDI Video Out
The Zynq Ult MPSoC (ZU11/17/19EG) Carrier board supports one 3G/12G SDI Video OUT interface through HD
BNC connector (J28).
Zynq Ult MPSoC’s
PL Bank227 Channel3 GTH transmitter from Board to Board
connector2 is directly connected to Cable Driver chip and then connected to HD BNC Connector (J28) for Video out.
The Zynq Ult MPSoC (ZU11/17/19EG) Carrier board supports Video Output Lock status LED (D16). This LED will
glow when the video signal from MPSoC GTH transmitter is detected on Cable Driver chip. Also PS I2C0 is connected
to Cable Driver chip for control and configuration with I2C address 0x30. SDI Video OUT HD BNC connector (J28) is
physically located at the top of the board as shown below.
Note: By default, 12G Adaptive Cable Equalizer chip “LMH1297” is supported on the board. To support 3G Adaptive
Cable Equalizer chip “LMH0397”, contact iWave.
Figure 20: SDI Video OUT HD BNC Connector