Ivoclar digital PrograMill Base, Руководство по эксплуатации

Страница: 73 / 144

Operating the Operating Panel
73
6.6.1 Section [Blocks]
In the [Blocks] section, you can see and change the status of the max. 5 blocks inserted in the
material and tool changer.
The 5 block holders and their occupation is shown:
The following list of features corresponds to the state of knowledge at the time of going to
print. With the introduction of new features, this list will be continuously updated.
Element Description Reference
No block inserted “Inserting blocks”, page 99
Block is inserted and marked for
identification: The Data Matrix Code
on the shaft will be read by the
camera integrated into
PrograMill One. -
Block is inserted and correctly
identified. It is not required for any of
the upcoming milling jobs and is
therefore not assigned to a job. “Removing blocks and restorations
which are no longer required”,
page 104