Isuzu NPR 2008, Руководство пользователя

Страница: 105 / 192

4-2
REMEMBER THESE BASIC STEPS BEFORE CLEANING:
1. Remove stains as quickly as possible before they become “set”.
2. Use a clean cloth or sponge, and change to a clean area often. A
soft brush may be used if stains persist.
3. Use solvent-type cleaners only in a well ventilated area: also, do
not saturate the stained area.
4. If a ring forms after spot cleaning, clean the entire area immediately.
5. Follow specific instructions on cleaner labels.
General Cleaning of Soiled or Water Spotted Fabric Type Trim With
Foam Type Cleaner
• Vacuum the area thoroughly to remove any loose dirt.
• Always clean a whole trim panel or section. Mask surrounding trim
along stitch or welt lines.
• Use suds on a clean sponge. Do not brush wet suede. Do not
saturate the material or rub it harshly. Immediately after cleaning,
remove suds with a sponge and rinse with a clean wet sponge. Wipe
off remaining residue with a slightly damp absorbent towel or cloth.
• Important — Immediately after wiping, force-dry the fabric with an
air hose. A heat dryer or heat lamp may be used. Use caution with
a heat dryer or lamp to help prevent damage.
• When trim materials with a sheen or luster finish are dry, wipe the
fabric lightly with a soft, dry, clean cloth to restore its sheen or luster.
For suede, raise nap with dry scrub brush and vacuum to remove
any final traces of residue.
Spot Cleaning Fabric Type Trim With Solvent Type Cleaner
Before trying to remove a spot or stain from fabric, try to find out the
type and age of the spot or stain. Some spots or stains can be removed
with water or a mild soap solution (see “Removal of Specific Stains”).
Spots or stains should always be removed as soon as possible.
Some types of stains or soilage, such as lipstick, inks and grease,
are very difficult (sometimes impossible) to remove completely. When
cleaning this type of stain or soilage, be sure not to enlarge the soiled
area.
• Gently scrape excess stain from the trim material with a clean, dull
knife or scraper. Use very little cleaner, light pressure, and clean
cloths (preferably cheesecloth). Cleaning should start at the outside
of the stain “feathering” towards the center. Keep changing to a
clean section of cloth.
• When you clean a stain from fabric, immediately dry the area with
an air hose, heat dryer, or heat lamp to help prevent a cleaning ring.
(Use caution with heat dryer or lamp to help prevent fabric damage.)
• If a ring forms, immediately repeat the cleaning operation over a
slightly larger area with emphasis on “feathering” towards its
center. If a ring still remains, mask off surrounding trim sections
and clean the entire soiled area with foam type cleaner.
55702_Sec04_'08 08.2.12 9:48 AM Page 2