Unplugging the device
24
USING MY W700-SC DEVICE
IronKey Workspace W700-SC User Guide
5.
The computer will reboot into the Windows operating system on the device.
6.
If this is the first time starting Windows, you may have to configure some Windows settings. Follow the
on-screen instructions. This is only required the first time you start Windows To Go.
7.
When Windows starts, type your Windows password (if applicable) to log into your Windows account.
Tip:
If the host computer is already running when you plug in the device, you can restart it and boot into
Windows To Go.
Note:
Each time you boot your device on different host computers, Windows To Go will adapt to the hardware
of the host computer to use its unique set of hardware components. The device stores a hardware profile for
each new host computer. This profile is used on subsequent startup procedures for a known host computer.
UNPLUGGING THE DEVICE
In Windows To Go mode, make sure that you properly shut down the Windows operating system before you
remove the device from the host computer.
If the device is being used in non-boot mode (that is, the device is not booted into Windows To Go and the
host operating system is running), you should lock the device (using IronKey Control Panel), and then safely
eject it from the host computer. For more information about locking a device, see “To lock the device” on page
12.
To shut down Windows
1.
In Windows To Go, move the mouse to the bottom-left corner of the screen and right-click the Windows
logo.
2.
Click
Shut down or sign out
and then click
Shut down
.
3.
When the operating system has shut down, unplug the device from the host computer.
Important:
Never remove the device while booted in Windows To Go. Doing so could corrupt Windows To Go.
If the device is accidentally unplugged while Windows To Go is running, the computer will freeze.
MANAGING YOUR SMART CARD AND PIN
If you lose your card or forget your PIN code, you will need to pair a new card with your device. Contact your
administrator to reset your smart card from the IronKey Enterprise Management System. The next time you
plug in your device, you will be prompted to insert the card and pair it with your device.
To pair a new card with your device
1.
Make sure that the host computer is turned on and the host operating system is running. The host com-
puter must have network access to the IronKey Enterprise Management System.
2.
Insert the device into the USB port of the host computer. USB 3.0 port is preferred but USB 2.0 is also
supported.
3.
Insert the smart card into the card reader if it is not already inserted.
Содержание Workspace W700-SC
Страница 1: ...IRONKEY WORKSPACE W700 SC User Guide ...
