31
aggregation group equals the total rate of its member ports.
2)
LACP
For LACP aggregation, you must manually maintain the aggregation state of the member ports. Whether ports in
LACP group are aggregation ports or not is determined by LLDPBU frame auto-negotiation. Down to 2 member
ports must be included in a single aggregation group. LACP is enabled on the member ports in LACP mode.
Ports in an LACP aggregation group may stay either in a forwarding status or a blocked status. Ports in LACP
aggregation group will be in a forwarding status. If all ports in the aggregation group are not aggregated, only the
first port will be in the forwarding status. Ports in forwarding status can send/receive both service packets and
LACP frames; ports in blocked status can only send/receive LACP frames.
Link Aggregation--- View & Config
Click
Port Management > Link Aggregation
to enter the main link aggregation interface:
Four widely used aggregation algorithms are listed below:
Algorithm
Description
Source MAC
Member ports in a link aggregation group share traffic load according to
source MAC addresses.
Dest MAC
Member ports in a link aggregation group share traffic load according to
destination MAC addresses.
Source & Dest MAC
Member ports in a link aggregation group share traffic load according to
source and destination MAC addresses.
Source & Dest IP
Member ports in a link aggregation group share traffic load according to
source and destination IP addresses.
Static Aggregation—Config
To enter the configuration screen as seen below, click
New
:
Содержание G3224P
Страница 1: ......
