4.2 Programming
Users
4.2.1 Adding New or
Changing Existing
Codes/Cards
The most basic prox.pad plus programming is adding
new codes or cards (users), or modifying existing codes
or cards (users). Each user entry consists of three or
four data values: a user type, a location and a keypad-
PIN, and/or card.
Two methods can be used for adding new or changing
existing codes/cards, (1) keypress sequences (manual
entry), and (2) card presentations. Keypad PINs can
be programmed only through a keypad sequence,
while card PINs can be programmed manually or by
presenting the card to the proximity reader at a speci-
fied time during programming.
Table 4-3 lists the specific types of users that can be
programmed with the prox.pad plus unit and the fol-
lowing section describe the various ways to program
users.
NOTE:
When 26-bit cards are used and you choose to
add new cards manually, the facility code MUST be
entered into the unit first. The default facility code is
11. For the programming sequence used to enter the
3-digit facility code, see command 32, parameter 4 (see
table in section 4.6).
4.2.2 Programming
Code and Card
Options
The prox.pad plus unit can be programmed to accept
the four code/card combinations listed below.
•
(1) Code ONLY (command 50)
•
(2) Code AND Card (command 50 plus present
card to proximity reader)
•
(3) Card ONLY (command 50 or command 51)
•
(4) Code OR Card (command 52)
NOTE:
No user can have the same card and/or
code PIN as another user.
4.2 Programming Users
Chapter 4: Programming
prox.pad plus Install/Program. Manual, PPP, D2
4-7