1.7 Items Supplied
from the Factory
The following items are supplied from the factory with
the initial prox.pad plus shipment.
•
Controller with Keypad, Faceplate, Request to Exit
(REX) button (also called the “Filler Piece”), three
Wire Harnesses, and various installation Screws.
1.8 Items the
Installer Must
Supply
For each initial prox.pad plus unit installation, the
installer must supply the following items:
•
The prox.pad plus unit works with these four
types of cards:
– Prox Card II
– IsoProx II
– Duo Prox II
– Proxkey FOB
•
an appropriately rated DC Power Supply (12 VDC)
(filtered and regulated recommended)
•
the appropriate installation electrical tools
•
the recommended remote antenna cable
[ALPHA 1174C (22AWG) 4-wire, stranded] (this is
required ONLY if you choose to remote the an-
tenna 10 feet away from the keypad/controller)
•
RS-485 cable (24AWG), shielded, two twisted-pair
telephone cable with a shunt capacitance of
16 pF/Ft (required only when using software)
•
power supply cable (18AWG-22AWG) 2-wire
stranded (depends on distance)
•
door lock cable (18AWG-22AWG) 2-wire stranded
(depends on distance)
•
door monitor cable (18AWG-22AWG) 2-wire
stranded (depends on distance)
•
REX cable (if using remote switch) 2-wire stranded
1.7 Items Supplied from the Factory
Chapter 1: Introduction
prox.pad plus Install/Program. Manual, PPP, D2
1-3