Intermec EasyLan AW02, Руководство пользователя

Страница: 44 / 126

Chapter 2 — Configuring EasyLAN Wireless
32 EasyLAN Wireless User’s Manual
TCP/IP Parameters Defined (continued)
Parameter Definition Values Default
RARP Boot
Settings Select whether RARP sets the subnet mask based on
the EasyLAN Wireless IP address and sets the gateway
IP address. To use these settings, set the boot method
to RARP or AUTO.
Select Set address with ARP/Ping if you are using
ARP to statically configure the EasyLAN Wireless IP
address. For help, see “Configuring the IP Address
Using ARP” on page 33.
No Subnet Mask,
No Gateway,
Set address with
ARP/Ping Set address with
ARP/Ping
TCP Window Enter the maximum TCP window for TCP
communications. Normally this value is set
automatically, but you may want to change it to
optimize network performance. 1,500 to 65,535
Set by network 10240
TCP Timeout Enter how many minutes or seconds a TCP job can be
idle before the job is terminated. If you set the timeout
to zero, the TCP job can be idle indefinitely. 0 to 255
min or sec
1 minute
LPD Settings Check the LPD Banner Enable check box to set
EasyLAN Wireless to print the banner page in an LPD
control file.
Check the LPD Retry Enable check box to set
EasyLAN Wireless to wait for an LPD job that has
been terminated before it was completed to be resent.
If the LPD job is resent, EasyLAN Wireless continues
printing the job where it had stopped.
Checked,
Cleared Cleared
Keepalive Timer Enter how often in minutes EasyLAN Wireless sends
an IP ping packet to the router to keep the router
aware of EasyLAN Wireless.
Enter 0 to disable this feature.
0 to 255 5 minutes
Probe Idle
Connections Select Enable if you want EasyLAN Wireless to send a
probe packet on TCP connections with no data traffic.
If EasyLAN Wireless does not receive an
acknowledgement, it closes the connection.
Enable,
Disable Disable
TCP Receive
Checksum Select Enable if you want EasyLAN Wireless to
compute the TCP checksum on received packets.
Select Disable to enhance performance, but data
corruption will not be checked.
Enable,
Disable Enable
Access Control Click Configure IP Access Control to configure the
range of IP addresses allowed to communicate with
this printer with EasyLAN Wireless.
IP addresses Blank