Seven: Checking Out and Troubleshooting the System
4
Providing a brighter solution.™
Check for successful wireless reception all around the yard
What to do
If it doesn’t work
Reference/Procedure
Wake up the Hand-Held
Remote by pressing any
button.
Identify and walk to the
areas where you intend
to use the Hand-Held
Remote, and make sure
you see
STAT OK
in the
upper left corner of the
display at all times in
these areas.
If the word
OK
disappears
and the display reads
only
STAT
, follow the
procedures in the next
column.
1.
2.
3.
Verify that the Hand- Held
Remote is working properly.
Follow the troubleshooting procedures on page
41
.
Verify that the Hand-Held
Remote is successfully
communicating with the
Panel-mounted Transceiver.
Stand next to the control box with the Hand-Held
Remote.
Verify that the unit works by locating and following the
“What to do” procedures detailed in
Check all circuits
using the Membrane Pad and Wireless Remote
on page
39.
1.
2.
Install Transceiver Repeater
Modules
(HA04C)
where
necessary to improve or
broaden range.
Locate a 120 Volt outlet someplace between the
Panel Mount Transceiver and the area the Hand Held
Transceiver lost communication.
Install a Transceiver Repeater Module
(HA04C)
in this
outlet and program the Repeater Module by following
the instructions on page
31
.
See page
9
for Transceiver Repeater Module ordering
information.
1.
2.
3.
Install the Intermatic 35-ft.
Antenna Extension Cable
Assembly
(PA121)
to
improve or broaden range.
If a 120 Volt outlet is not strategically located or the
Transceiver Repeater Module doesn’t work, you
may have to remote the antenna on the Panel Mount
Transceiver located on the top of the enclosure.
NOTE:
Only an Intermatic 35-ft. Antenna Extension
Cable Assembly (PA121) will work with the Mini-Wave
Control. Ordering information is located on page 8.
Remove the antenna located at the top of the Panel-
Mounted Transceiver by turning the antenna counter
clockwise.
Install the female end of the cable where the antenna
was previously connected.
Install the antenna on the other end of the cable.
Route the cable to a location where the antenna will be
in the direct Line of Sight of the area where the Hand-
Held Remote will be most frequently used.
Mount the cable and antenna with the mounting
kit that comes with the Intermatic 35-ft. Antenna
Extension Cable Assembly
(PA121)
.
Repeat the “What to do” procedure to verify that your
installation was successful.
1.
2.
3.
4.
5.
6.
7.
