4
Mini-Wave PE4 Installation Guide
Copyright © 2006 Intermatic, Inc.
Installing a Water Feature
Your Mini-Wave Control System can be configured to control up to two more actuators or one
additional actuator and relay that work simultaneously. Either of these two configurations will
work with Button
<3>
on both the Wireless Hand-Held Transceiver and Control Panel and work
independently of your Pool/Spa Actuators. Refer to pages
7
and
8
for ordering the optional relay
and/or actuators.
If installing the optional relay, refer to page
23
for installation procedures.
Remove the Control Panel Deadfront to gain access to the Control Boards.
Route the low-voltage cable from the actuator through the low-voltage raceway and plug the
connector into either of the two available three-pin plugs on the upper Control Board.
Refer to the appropriate programming section if special programming is required.
Depending on the configuration above, Button
<3>
will now control this feature.
Some examples of this feature are:
Cleaner Pump and Actuator combination
Water Fountain (pump and light) and Actuator combination
Spill-Over Spa Control
NOTE:
When installing the optional relay, you must purchase the Optional Relay Kit
(PA120)
.
This relay must have a 24VAC coil,
NOT A 24VDC COIL
like the remaining four relays. If the
24VDC coil relay is installed, the relay will chatter and could cause a failure of the pool or spa
equipment.
1.
2.
3.
•
•
•
24VAC Actuators
Water Feature
Upper Control
Board
Circuit
#3
Two Actuator Configuration
24VAC Actuators
Water Feature
Upper Control
Board
Circuit
#3
Two Actuator Configuration
Upper Control Board
24VAC Actuator
Water Feature
24VAC Coil
Wires
One Actuator and One Relay Configuration
Circuit
#3
Upper Control Board
24VAC Actuator
Water Feature
24VAC Coil
Wires
One Actuator and One Relay Configuration
Circuit
#3
Figure 5-5
Figure 5-5
Button <3>
Button <3>
Figure 5-4
Figure 5-4
