Three: Control Center Installation
1
Providing a brighter solution.™
Motorized Valve Actuator Connection and Synchronizing
The Mini-Wave Control System is capable of controlling up to three Motorized Valve Actuators
on the Pool/Spa (P/S) circuit, and up to two additional Motorized Valve Actuators on circuit
number three. Two Intermatic Motorized Valve Actuators
(PE24VA)
are included with your Mini-
Wave system. Refer to page
7
for ordering information.
The actuators
must be installed
to automatically
rotate your valves
between pool and
spa plumbing. Power
must be disconnected
when connecting the
actuator connectors
to your Mini-Wave
Control Center. Refer
to the directions below
prior to installing your
PE24VA actuators. Refer
to Figure 3-9 for detail.
Remove power from the Mini-Wave control center.
Attach the valve actuators
(PE24VA)
to the water valves. (See instructions included.)
Run the actuator cable to the Control Center, and through the low voltage raceway.
Insert the three-pin connector of the motorized valve actuator to any of the three available
connectors on the Lower Control Board.
Apply power to the Mini-Wave Control Center and synchronize the actuators as follows:
Push and release the P/S button located on the Membrane pad to illuminate the green light
beside the P/S button. This indicates that the control and actuators are in the SPA mode.
Use the switch located on your motorized valve actuator to ensure the valves are in the
SPA position.
NOTE:
If either of the Actuators is positioned backwards, flip the switch on the back to
reverse position.
Verify that the Actuators are correctly synchronized with your installation.
If installing an actuator for a separate water feature or cleaner pump is required, insert the
three-pin connector of the motorized valve actuator to any of the two available connectors on
the Upper Control Board.
Push and release the #3 button located on the Membrane pad to illuminate the light beside
the #3 button. This indicates that the control and actuator have activated the additional
water feature.
Use the switch located on your motorized valve actuator to ensure the valves are in the
water feature position.
NOTE:
If the actuator is positioned backwards, flip the switch on the back to reverse position.
1.
2.
3.
4.
5.
a.
b.
c.
6.
a.
b.
Low
Voltage
Raceway
24 VAC Actuators Water Feature
24 VAC Actuators Pool/Spa Diverters
Upper Control Board
Lower
Control
Board
Membrane Pad
P/S
Low
Voltage
Raceway
24 VAC Actuators Water Feature
24 VAC Actuators Pool/Spa Diverters
Upper Control Board
Lower
Control
Board
Membrane Pad
P/S
Figure 3-9
Figure 3-9
