Three: Control Center Installation
1
Providing a brighter solution.™
Connection for Hayward Heaters
rs
Remove heater service door on your Hayward
Heater.
Remove factory-installed wire connector between
two (2) red wires labeled “CONNECTION FOR
FIELD INSTALLED CONTROL SWITCH.” (See
Figure 3-13.)
Connect two #14 gauge wires, designed for use
in hot environments, to the two red wires. (See
Figure 3-14.)
Wire the other end to the two brown wires,
marked heater connection, on the panel-mounted
receiver in your Mini-Wave Control Center.
Do not disconnect high limit or pressure switches.
Turn the heater thermostat(s) to maximum setting.
Turn the thermostat selector switch to the ON,
HIGH, or SPA position.
Connection for Pentair Heater
Remove heater service door on your Pentair
Heater.
Separate the black wires (common) from each
other. (See Figure 3-15.)
Connect two #14 gauge wires, designed for use in
hot environments, to the two brown wires, marked
heater connection, on the panel-mounted receiver
in the Mini-Wave Control Center and attach the
other end to the two black wires on the heater.
(See Figure 3-16.)
Do not disconnect high limit or pressure switches.
Turn the heater thermostat(s) to maximum setting.
Turn the heater toggle switch on.
1.
2.
3.
4.
5.
6.
7.
1.
2.
3.
4.
5.
6.
Limit Switch
Limit Switch
Pressure Switch
Factory
Installed
Wire Nut
Limit Switch
Limit Switch
Pressure Switch
Factory
Installed
Wire Nut
Limit Switch
Limit Switch
Pressure Switch
Wires to Panel-
Mounted Transceiver
Limit Switch
Limit Switch
Pressure Switch
Wires to Panel-
Mounted Transceiver
Figure 3-13 — Wiring Before Modification
Figure 3-13 — Wiring Before Modification
Figure 3-14 — Wiring with Panel-Mounted Transceiver
Figure 3-14 — Wiring with Panel-Mounted Transceiver
Wires from
Power Center
PCB
Wires from
Power Center
PCB
Figure 3-15 — Wiring Before Modification
Figure 3-15 — Wiring Before Modification
Figure 3-16 — Wiring with Panel Mounted Transceiver
Figure 3-16 — Wiring with Panel Mounted Transceiver
