1
Mini-Wave PE4 Installation Guide
Copyright © 2006 Intermatic, Inc.
Section 3:
Control Center Installation
Mounting the Control Center
Special code requirements apply to your Mini-Wave
Control System. To ensure safe installation, please
follow all applicable national state, and local codes
when installing the Control Center.
Locate your Control Center near the pool/spa
equipment pad at least five feet or more away from
either the pool or spa equipment and at least five feet
off the ground.
Mounting brackets have been provided to assist you in
your installation.
NOTE:
The Control Center is not to be considered
as suitable for use as Service Equipment. Therefore,
it is required to have the appropriate means of
disconnection, circuit isolation, and/or branch circuit
protection installed at the Main Power Panel.
Wiring the System Power
Run wire from the Main Power Panel
to your Control Center and connect the
leads to the Control Center Breaker Base.
See detail in Figure 3-2 at the right.
The breaker base of your Control Center is
capable of handling up to 100 amps. You
must comply with the applicable local
codes and use the proper gauge wiring
from your Main Power panel to your
control center breaker base. The proper
gauge wire will be determined by the
length of wire required and the 100 Max
Amp rating.
WARNING: Potentially high voltages
in the Control Center can create
dangerous electrical hazards, possibly
causing death, serious injury, or
property damage. Turn off the Main
Power to the Control Center to
disconnect or service the Mini-Wave
Control Center.
Figure 3-1
Figure 3-1
Buss
White
Earth
Ground
Black
Red
From Main
Power
Buss
White
Earth
Ground
Black
Red
From Main
Power
Figure 3-2
Figure 3-2
