Six: Programming the Hand-Held Transmitter
Providing a brighter solution.™
Using Two Hand-Held Controllers to Operate the System
When two or more Hand-Held Controllers are being used to operate a system, each will
synchronize itself to the other according to whatever function the other controller has activated.
For example, if you press the
<1>
button on one controller, the following will happen:
Circuit 1
at the control center will toggle on or off, depending on its current state.
The number
1
will appear along the top of the Hand-Held Controller’s screen.
Then, a few seconds later, the number
1
will also appear along the top of the second
Hand-Held Controller’s screen.
The owner can add up to five Hand-Held Controllers to a system.
Adjusting the display temperature on the Wireless Hand-Held
Transceiver
There are many variables that can affect the temperature displayed on your Wireless Hand-Held
Transceiver. These can range from where the water temperature sensor is located, the difference
in water temperature at the top vs. the bottom of your pool or spa, or even another temperature
you are referencing. Whatever the case, you can adjust your temperature display on your
Wireless Hand-Held Transceiver to compensate for these different variables.
It’s best to adjust this value while standing close to the panel to ensure good communication
between the Hand-Held Remote and Panel Mount Receiver.
Press and release any button on the Hand-Held Remote to wake it from sleep. (The unit goes
to sleep to conserve battery life when it has been idle for 30 seconds).
Press and hold the
<P/S>
and
<CHLR>
buttons at the same time for about 5 seconds. This will
put the device in programming mode.
Press and release the
<5>
button to select
MORE OPTIONS
. A new screen will appear.
Press and release the
<3>
button on the new screen to select
ADJUST TEMP 0
.
Press and release the
<UP>
or
<DOWN>
arrow buttons to raise or lower the desired value
that should be added or subtracted to the temperature display.
Press and release the
<3>
button to save your desired value. The word
SUCCESS
should
display at the bottom of the screen.
NOTE:
If the word SUCCESS does not display at the bottom of the screen after saving your
new value then the new value did not save and the setting will default to the previously saved
value. This is due to miscommunication between your Hand Held Remote and Panel Mount
Receiver. Refer to page 28 for instructions on Synchronizing the Hand-Held with the Panel-
Mounted Receiver.
Press and release the <CHLR> button to exit programming mode.
The temperature display should now show a new value based on your programmed adjustment
level.
•
•
•
1.
2.
3.
4.
5.
6.
7.
8.
