Six: Programming the Hand-Held Transmitter
1
Providing a brighter solution.™
Installing the 35-ft. Antenna Extension Cable
(PA121)
Choose a location for the antenna within 35 feet of the Control Center
that will be in direct line of sight from the area of operation — where the
home owner will be using the Hand-Held Remote.
Unscrew the antenna from the top of the Panel-Mounted Transceiver.
Screw the male end of the 35-ft. Antenna Extension Cable into the top of the Panel-Mounted
Transceiver.
Run the cable underground from the Control Center to the location that will provide a direct
line of sight between the Hand-Held Remote and the area of operation.
Screw the antenna into the female end of the 35-ft. Antenna Extension Cable.
Securely mount the end of the cable with the antenna in the air.
Installing and Configuring Optional Repeaters
When you have installed the Antenna Extension Cable and are encountering
further communications problems, typically if the home owner wants to be
able to use the Hand-Held Remote from inside the house, order and install
optional Transceiver Repeater Modules
(HA04C)
to the system, plugging them
into 120 volt electric outlets where available.
Repeaters can relay signals to bridge between a dead spot and the Control
Center.
NOTE:
The relay between Repeaters and the rest of the system causes a delay in response time.
Wait a few seconds for commands you enter on the Hand-Held Remote to register.
Plug a Transceiver Repeater Module
(HA04C)
into any electrical outlet that is located where
you have determined a reception problem can be solved.
If necessary, press any button on the Hand-Held Remote to wake it
from sleep. Because you are at a location in between the control
center and the problem area, the screen display on the Hand-Held
will look generally like the example on the right.
Press and hold the
<P/S>
and
<CHLR>
buttons at the same time for
about 5 seconds. This will put the device in programming mode, as
shown at the right.
NOTE:
If you pause in the programming procedure for 30 seconds,
the screen automatically returns to Step 2.
Press the
<3>
function button to select
RESET NODE
. The screen
refreshes and displays only the line
3 RESET NODE
, as shown.
1.
2.
3.
4.
5.
1.
2.
3.
4.
Antenna Extension Cable
Assembly (PA121)
Antenna Extension Cable
Assembly (PA121)
Transceiver Repeater
Module (HA04C)
Transceiver Repeater
Module (HA04C)
STAT
OK
POOL
72
ºF SET
P 72
S 85
STAT
OK
POOL
72
ºF SET
P 72
S 85
LEA RN VER P
1 INC LUDE NO DE
2 ADD TO GROUP
3 RES ET N ODE
4 RES ET C ONTROLLE R
5 MORE OP TIO NS
C EXI T
LEA RN VER P
1 INC LUDE NO DE
2 ADD TO GROUP
3 RES ET N ODE
4 RES ET C ONTROLLE R
5 MORE OP TIO NS
C EXI T
LEAR N VER x
3 RES
ET N ODE
LEAR N VER x
3 RES
ET N ODE
