MP73P+ : Battery charger/analyser
Operators Manual
7.2
Capacity Test To Target Voltage
This mode will discharge the battery at the predefined current until the target voltage is
reached. At this point the unit will stop and report the battery capacity as follows: -
This mode can be used to discharge the battery and report the actual battery capacity.
The parameters required for this mode are as follows: -
Target Volts :
This is the point at which the discharge will stop.
Discharge Amps :
This is the constant current amps to discharge the battery. This is
usually the A/H rating of the battery.
Test Time :
This is required to calculate the actual capacity of the battery at the end
of the test. This is usually 1 Hour.
Doc: DWG1042-12-R18 MB73P+ Operators manual.odt
Page 33 of 64
Copyright Material of Intelligent Charging Limited © 2020
Printed On : 29/11/20
ACTUAL CAPTEST TIME
CAPTEST TIME
100
X
%BATTERY CAPACITY =
MAINTAIN
TEST
CURRENT
STOP CAPTEST
START
HAS TIME
ELAPSED
?
CLR KEY
PRESSED
?
NO
YES
YES
NO
