Intelligent Charging MB73+, Руководство оператора

Страница: 49 / 64

MP73P+ : Battery charger/analyser
Operators Manual
Select PRINT to make a hard copy of all the process steps.
Select EXECUTE to start the process.
9.2.1 Renaming a process
A process name can consist of any types characters up to a maximum of ten.
To create letters above C the
‘A’ key must be pressed repeatedly to go through all the
letters in the alphabet, upper case only. To create punctuation mark and space the ‘.’
must be pressed repeatedly. One the desired character has been selected a pause of
approx. 1 second must be observed to move the cursor to the next character position
on the next keypress.
9.2.2 View or Edit A Process
When view or edit is pressed the details of the first process step will be displayed. If the
process step has no data the display will show ""
PRESS MODIFY TO CREATE STEP ".
Selecting NEXT STEP will advance the process step to the next, until the last empty
slot, or step 6, where it will then revert back to Step 1.
Selecting PREV STEP
will cause the display to step back one step. Once step #1 is
reached it will then revert back to the last empty step or step #6.
Selecting
CLR STEP will
cause the current process step to be cleared. If a step is
cleared the steps that follow this step will be moved down one place, i.e. If step 3 is
cleared step 4 will replace it, step 4 will be replaced by step 5, step 5 replaced by step
6 and step 6 will be cleared to a no action step.
Selecting MODIFY
will start the data entry procedure. The display will show SELECT
MODE.
Select
>> NEXT >> or << PREV << to change to either : -
DISCHARGE BATTERY
CHARGE BATTERY
Press ENT to select either mode of operation.
The display will then ask for the charge or discharge data as per 8.2 Entering Charge
Data or 8.3 Entering Discharge Data. Once the data entry is complete the display will
show the data that has been selected.
9.3 Process Execution
To execute a process one must already be defined and properly configured. To start the
process the following procedure must be applied.
•
Check battery is correctly connected and a voltage is displayed in the main
Doc: DWG1042-12-R18 MB73P+ Operators manual.odt Page 49 of 64
Copyright Material of Intelligent Charging Limited © 2020
Printed On : 29/11/20