Operating Instructions
1
01825E
24 VOLT FULLY AUTOMATIC
BATTERY CHARGER
MODEL 26340L
TYPE 24EL20-4ET
Specifications
AC
Supply:
120 volts, 9.5 Amps, 60 Hertz, single-phase
DC Output:
24 volts DC, 20 amps
Battery Capacity:
Use only on 24 volt, 12 cell, 150 to 225 ampere-hour (6 hr. rate) liquid electrolyte
lead acid batteries
PLEASE SAVE THESE IMPORTANT SAFETY AND OPERATING INSTRUCTIONS
For correct operation of the equipment, it is important to read and be familiar
with this entire manual before installing and operating the charger.
DO NOT DISCARD THIS MANUAL AFTER READING.
LOOK FOR THIS SYMBOL TO POINT OUT SAFETY PRECAUTIONS. IT MEANS:
BECOME ALERT—YOUR SAFETY IS INVOLVED.
IF YOU DO NOT FOLLOW THESE
SAFETY INSTRUCTIONS, INJURY OR PROPERTY DAMAGE CAN OCCUR.
IMPORTANT SAFETY INSTRUCTIONS
Read and understand this entire manual before
installing or operating the charger. Follow all
instructions on the charger, battery, and battery
powered equipment.
INTRODUCTION
This battery charger provides superior battery
performance and life, with low electrical power
consumption. The solid state design provides a
highly reliable, self-regulating charger with a
minimum of moving parts, designed for long,
trouble-free service. When the battery has
reached its maximum state of charge, the solid
state control turns the charger off.
INSTALLATION
DANGER: TO AVOID ELECTRIC SHOCK,
NEVER ATTEMPT TO INSTALL OR REMOVE
CHARGER TO OR FROM BATTERY TRAY
WHILE THE CHARGER IS CONNECTED TO
THE AC SUPPLY OR BATTERIES.
CAUTION: NEVER ATTEMPT TO LIFT THE
CHARGER BY PULLING ON THE AC CORD.
CAUTION: WHEN PLACING THE
CHARGER INTO THE CHARGER COMPART-
MENT OF THE BATTERY TRAY, ALWAYS
PLACE THE CHARGER WITH THE
VENTILATION HOLES FACING THE VENTI-
LATION HOLES IN THE BATTERY TRAY.
