Intel UltraBookIIi, Руководство пользователя

Страница: 144 / 158

E–4 UltraBookIIi User Guide
The UltraBookIIi supports simultaneous
on-board and external video device display
using VESA standard 1024 x 768 x 60 Hz
mode and timing.
Changing Resolutions
Changing the display resolution is best done during the
boot sequence, either during start-up or rebooting
specifically to change the resolution.
1. To enter the command string, press “Stop”
and “A” together during the boot sequence,
right after the memory test and before the
hard disk begins accessing.
The workstation will then be in “Open Boot PROM”
(OBP) mode.
You can now execute OBP commands. Enter
the command for the desired resolution
corresponding to the type of display you have.
2. After entering the command string, type go
or
boot
, depending on any messages given
at the command line.
3. Press
Enter
to resume using the Ultra-
BookIIi.
UltraBookIIi Creator 3D Display and Resolution
Control
The UltraBookIIi with Creator 3D Graphics option
supports a 14.1" 1024x768 LCD as well as an external
13W3 connector for driving CRT monitors and
projection display devices. Simultaneous output to the
LCD and external port are supported at 1024x768 60 Hz
only. The LCD and external port configuration can be
determined using one of the following ways:
•
Configuring the port automatically at
system power up (see “Configuring the
Display Automatically,” on page E-5)