Intel® Server Board M50CYP2SB Family Technical Product Specification
139
Figure 70. Processor Heat Sink Handling
H.2.1 Processor Heat Sink Module (PHM) and Processor Removal
Figure 71. PHM Assembly Removal from Processor Socket
1.
Power off the system and disconnect the power cable(s).
2.
Remove the system top cover, if needed.
3.
Remove the air duct, if needed.
4.
Ensure all four heat sink anti-tilt wires are in the outward position (see Letter A).
5.
Then fully unscrew all four heat sink fasteners in any order (see Letter B).
6.
Set all four anti-tilt wires on the heat sink to the inward position (see Letter C).
7.
Lift the PHM straight up off the server board (see Letter D).
8.
After removing the PHM, visually inspect that the socket is free of damage or contamination.
Caution:
If debris is observed, blow it away gently. Do not use tweezers or any other hard tools to remove
the debris.
9.
If not replacing the processor, reinstall the socket cover.
Содержание M50CYP2SB Series
Страница 2: ...2 This page intentionally left blank...