Integra DTR-50.5, Инструкция по эксплуатации

Страница: 73 / 108

Advanced Operations
En-73
Operating
procedure
(
➔
page 58 )
■
GAME2, BLUETOOTH
`
Off :
No trigger signal is output.
A 12-volt trigger signal is output when the connected
component is selected as the source for:
`
Main
Note
• By default, “ BLUETOOTH ” input source on the “ 12V
Trigger A Setup ” menu and that on “ 12V Trigger B Setup ”
menu are set to “ Main ”, and that on “ 12V Trigger C Setup ”
is set to “ Off ”.
Multi Zone
■
Zone 2 Out, Zone 3 Out
`
Fixed :
The Zone 2/3 volume must be set on the amp in
that zone.
`
Variable :
The Zone 2/3 volume can be set on the AV
receiver.
If you’ve connected your Zone 2/3 speakers to an
amp with no volume control, set the “
Zone 2 Out ” and
“ Zone 3 Out ” setting, respectively, to “ Variable ” so
that you can set the volume, balance, and tone of
zone 2 and volume of zone 3 on the AV receiver.
■
Zone 2 Maximum Volume,
Zone 3 Maximum Volume
`
Off , 50 to 99 (Absolute display)
`
Off , –32dB to +17dB (Relative display)
With this setting, you can limit the maximum volume
for Zone 2/3.
■
Zone 2 Power On Volume,
Zone 3 Power On Volume
`
Last , Min , 1 to 99 or Max (Absolute display)
`
Last , – Q dB , –81dB to +18dB (Relative display)
This setting determines what the volume will be for
Zone 2/3 each time the AV receiver is turned on.
To use the same volume level as when the AV
receiver was last turned off, select “
Last ”.
The “ Zone 2 Power On Volume ” and “ Zone 3 Power
On Volume ” cannot be set higher than the “ Zone 2
Maximum Volume ” and “ Zone 3 Maximum Volume ”
setting.
Tuner
■
AM/FM Frequency Step (North American
models)
`
10kHz/200kHz :
`
9kHz/50kHz :
Select the frequency step according to your
area.
■
AM Frequency Step (Australian models)
`
10kHz :
`
9kHz :
Select the frequency step according to your
area.
For AM/FM tuning to work properly, you must specify
the AM/FM frequency step used in your area.
Note
• When this setting is changed, all radio presets will be
deleted.
HDMI
■
HDMI CEC (RIHD)
`
Off
`
On
Turn this setting on to allow p -compatible
components connected via HDMI to be controlled by
the AV receiver (
➔
page 17 ).
7. Hardware Setup