Integra DTR-50.5, Инструкция по эксплуатации

Страница: 21 / 108

Connections
En-21
With
u
(Remote Interactive), you can use the
following special functions:
■
System On/Auto Power On
When you start playback on a component connected
via
u
, while the AV receiver is on standby, the AV
receiver will automatically turn on and select that
component as the input source.
■
Direct Change
When playback is started on a component connected
via
u , the AV receiver automatically selects that
component as the input source.
■
Remote Control
You can use the AV receiver’s remote controller to
control your other
u -capable Integra/Onkyo
components, pointing the remote controller at the AV
receiver’s remote control sensor instead of the
component. You must enter the appropriate remote
control code first (
➔
page 83 ).
Note
• Use only u cables for u connections. u cables are
supplied with Integra/Onkyo components.
• Some components have two
u
jacks. You can connect
either one to the AV receiver. The other jack is for
connecting additional
u -capable components.
• Connect only Integra/Onkyo components to u jacks.
Connecting other manufacturer’s components may cause a
malfunction.
• Some components may not support all u functions. Refer
to the manuals supplied with your Integra/Onkyo
components.
• While Zone 2/3 is on, the System On/Auto Power On and
Direct Change u functions do not work.
Connecting Integra/Onkyo RI
Components
1 Make sure that each Integra/Onkyo component
is connected with an analog audio cable
(connection
I in the hookup examples)
(
➔
page 16).
2
Make the
u
connection (see the illustration).
3
If you’re using an RI Dock, or cassette tape
deck, change the Input Display (
➔
page 51).
L R
ANALOG
AUDIO OUT
L R
ANALOG
AUDIO OUT
e.g., cassette tape deck
RI Dock
Using Headphones
1 Connect a pair of stereo headphones with a
standard plug (1/4 inch or ø
6.3 mm) to the
Phones jack.
While the headphones plug is inserted in the
Phones jack, = indicator, speaker/channel
indicator FL and FR lights.
Note
• Always turn down the volume before connecting your
headphones.
• While the headphones plug is inserted in the Phones
jack, the speakers are turned off. (The Zone 2/3
speakers are not turned off.)
• When you connect a pair of headphones, the listening
mode is set to Stereo, unless it’s already set to Stereo,
Mono, or Direct.