Playback
En-50
You can display various information about the current
input source as follows.
The following information can be typically displayed.
*1
If the input signal is digital, the signal format is displayed.
With the sleep timer, you can set the AV receiver to
turn off automatically after a specified period.
You can adjust the brightness of the AV receiver’s
display.
Displaying Source Information
1
Press Receiver once followed by Display
repeatedly to cycle through the available
information.
Tip
• Alternatively, you can use
Display
on the AV receiver.
Sampling
frequency
Input source
Signal format
*1
Listening mode
Input signal
resolution
Output resolution
Using the Sleep Timer
1
Press Receiver once followed by Sleep
repeatedly to select the required sleep time.
The sleep time can be set from 90 to 10 minutes
in 10 minute steps.
The
SLEEP
indicator lights on the AV receiver’s
display when the sleep timer has been set. The
specified sleep time appears for about 5
seconds, then the previous display reappears.
Tip
• If you need to cancel the sleep timer, press
Sleep
repeatedly until the
SLEEP
indicator goes off.
• To check the time remaining until the AV receiver
sleeps, press
Sleep
. Note that if you press again on
Sleep
as the time being displayed is 10 minutes or
less, the sleep timer will go off.
Setting the Display Brightness
1
Press Receiver once followed by Dimmer
repeatedly to switch between: normal, dim, or
dimmer brightness.
Tip
•
(North American models)
Alternatively, you can use
Dimmer
on the AV receiver.
Содержание DTR-50.5
Страница 1: ...AV Receiver DTR 50 5 Instruction Manual...
