Inmes IM-300PL AL, Руководство оператора

Страница: 22 / 66

Fig. 30 Fig. 31
4)
Press the right pedal and then press the buttons 01 and 02 at the same time (Fig. 28 and 29). (Keep pressed
the pedal as well as the two buttons 01 and 02 until the sawblades descent completely. If you release the ped-
al and buttons the sawblade will return to its original position, not finishing the cut);
5) Release the buttons 01 and 02 as well as the pedal.
6) Remove the piece of moulding that will make part of the picture framing;
7) Move the profile around 30,00mm backwards in order to avoid waste;
8) Press the left pedal and then press the buttons 01 and 02 at the same time (Fig. 28 and 29). (Keep pressed
the pedal as well as the two buttons 01 and 02 until the sawblades descent completely. If you release the ped-
al and buttons the sawblade will return to its original position, not finishing the cut);
9) Move the profuile until the molding stop;
10) Repeat this process as many times it is necessary;
11) Once you finish make sure to turn the machine off by pressing the red button 02 (Fig. 27).
By following this proceed you will avoid wasting material , but if you
need more productivity, follow the steps bellow:
1) Move the profile until the molding stop;
2) Press both pedals and then press the buttons 01 and 02 at the same
time (Fig. 28 and 29). By doing it, the both sawblades will descend at
the same time, increasing your productivity. .
Remember: Operating on that way, your waste will be bigger.
Fig. 32
INMES Industrial Ltda – Double Miter Saw IM-300PL 21