Inmes IM-300PL AL, Руководство оператора

Страница: 17 / 66

5. 4 - Air Supply
As requirement to work properly, it is necessary to use air compressor at least 2ft³/min. It can be in-
stalled using a compressor with a greater output, but not smaller.
The operating pressure should be between 6 bar (Kg/cm²) and 8 bar (Kg/cm²).
6 - OPERATION
6. 1 – Cutting adjustments
First of all the operator must select the moulding that he wants to cut. Before making any adjustments
make sure the machine is in turned OFF for operator safety.
6. 1 . 1 – Minimum lenght of the profile to be cut
For a small profile it is necessary to follow some procedures as described below:
When the moulding stop is leaning on the part 01 (fig. 14) the measure “A” it is 244mm, if necessary to
cut a smaller profile than 244mm, remove the part 01 using a 5mm Allen wrench to loosen the screws 02 (not re-
move). The 5mm Allen wrench it is not supplied with the equipment. Now, sliding the part 01 to the right to remove
it. Now slide the moulding stop next to the part 03 (fig. 15). This way the measure “B” will be 94mm.
Fig. 14
Fig. 15
Importante:

Choose the proper blade for each type of
material to be cut.
W A R N IN G

The IM-300PL is designed to use blades with
the diameter of 300mmn central hole of 30mm
and the thickness cannot exceed 3,4mm.
D A N G E R

Never use your machine if you observer something
which can cause an accident. Make sure all the
safety protections are in perfect working condi-
tion.

After changing or servicing the blades double
check and make sure the blades are properly
tightened before turning the machine on.
INMES Industrial Ltda – Double Miter Saw IM-300PL 16