INIM SmartLoop Series, Руководство по установке

Страница: 49 / 60

Installation manual
Argus Devices 49
Appendix B
Argus Devices
Note:
The ARGUS devices accepted by this control panel do not have IMQ-SECURITY SYSTEMS certification, refer
to the instructions leaflet provided with each device.
All Argus Vega devices have built-in loop isolators. Therefore, isolators are not required. A short-circuit on
the loop will not provoke loss of any device.
Each detector is equipped with a 3-colour LED: green (periodic blinking) indicates the detector is working
properly (if enabled). Yellow indicates that the detector is not operating properly (fault) or has an open
isolator, whereas red indicates alarm status.
Detectors are equipped with test LEDs: if you hold a magnet near the detector base (near to the two
notches) the detector should generate an alarm signal.
B.1 Devices
Model Name Description
V100 Analogue optical detector Optical smoke detector
V200 Analogue Multicriteria detector Optical smoke&heat detector
V350 Analogue temperature detector
Heat detector (
a
)
VCP100 Intelligent resettable callpoint Callpoint with resettable mechanism
VWCP100 Weatherproof intelligent resettable callpoint Callpoint with resettable mechanism for outdoor installation
VMI100 Input module Module with 1 supervised input
VMMI100 Input Minimodule Reduced-size module with 1 supervised input
VMDI100 DIN rail input module DIN rail module with 1 supervised input
VUMI100 Input Micromodule Reduced-size module with 1 supervised input
VMC100 Output Module Module with 1 Supervised Output
VMMC100 Output Mini Module Reduced-size module with 1 supervised output
VMDC100 DIN rail output module DIN rail module with 1 supervised output
VUMC100 Output Micromodule Reduced-size module with 1 supervised output
VMC120 Output Module Form C Module with 1 voltage-free output (non-supervised)
VMMC120 Output Mini Module Form C Reduced-size module with 1 voltage-free output (non-supervised)
VMDC120 DIN rail output module Form C DIN rail module with 1 voltage free relay (non-supervised)
VUMC140 Output Micromodule Form C Reduced-size module with 1 voltage-free output (non-supervised)
VMIC100 Input/Output Module Module with 1 supervised input + 1 supervised output
VMMIC100 Input/Output Mini Module Reduced-size module with 1 supervised input + 1 supervised output
VMDIC100 DIN rail Input/Output module DIN rail module with 1 supervised input + 1 supervised output
VMIC120 Input/Output Module Form C Module with 1 supervised input + 1 non-supervised output (voltage-
free contact)
VMMIC120 Input/Output Mini Module Form C Reduced-size module with 1 supervised input + 1 non-supervised
output (voltage-free contact)
VMDIC120 DIN rail Input/Output module Form C DIN rail module with 1 supervised input + 1 non-supervised output
(voltage-free contact)