To complete the configuration change, the unit must be marked appropriately. There is a space on the ratings plate
on which to mark some of the standards with which the unit complies, because this is the way the authorities which
demand compliance require it. The standards which it is obligatory to mark are:
NEVER PLACE THE LABEL UNLESS THE INVERTER FULFILS THE IDENTIFIED
CONFIGURATION
Incorrectly marking a unit can constitute a breach of laws or regulations.
INGETEAM ENERGY
S.A. accepts no liability for the consequences which can result from erroneous or fraudulent marking of
its units due to failure to comply with these instructions.
STOP
- “VDE0126-1-1” for changes to configuration for GERMANY and
FRANCE.
- “RTC alle rete BT Enel Distribuzione - CEI 11-20:2000, CEI 11-20
V1:2004” for changes to configuration for ITALY.
Two labels will be included together with the unit documentation to
stick under the ratings plate in these cases. The illustration shows
where these are to be located:
VDE 0126
RTC alle rete Enel Distribuzione
CEI 11-20, CEI 11-20 V1
9.5.2 Nominal grid voltage
This menu is for configuring the output voltage on the terminal strips.
It is not used for any of the models to which this manual refers.
STOP
Installation Manual
INGECON
®
SUN SMART TL
AAY2000IKI03
AAY2000IKI03
Rev. _
Date: March 2011
Page 49 of 64
49 of 64
of 64
