Ingersoll-Rand TS10A, Руководство по эксплуатации и обслуживанию

Страница: 4 / 204

2.0 FOREWORD
TS1A–13A
http://air.irco.com
2
The contents of this manual are considered to be proprietary and
confidential to Ingersoll Rand and should not be reproduced without the
prior written permission of Ingersoll Rand.
Nothing contained in this document is intended to extend any promise,
warranty or representation, expressed or implied, regarding the
Ingersoll Rand products described herein. Any such warranties or
other terms and conditions of sale of products shall be in accordance
with the standard terms and conditions of sale for such products, which
are available upon request.
This manual contains instructions and technical data to cover all routine
operation and scheduled maintenance tasks by operation and
maintenance staff. Major overhauls are outside the scope of this
manual and should be referred to an authorized Ingersoll Rand
service department.
All components, accessories, pipes and connectors added to the
compressed air system should be:
.
of good quality, procured from a reputable manufacturer and,
wherever possible, be of a type approved by Ingersoll Rand.
.
clearly rated for a pressure at least equal to the machine maximum
allowable working pressure.
.
compatible with the compressor lubricant/coolant.
. accompanied with instructions for safe installation, operation and
maintenance.
Ingersoll Rand reserves the right to make changes and improvements
to products without notice and without incurring any obligation to make
such changes or add such improvements to products sold previously.
Details of approved equipment are available from Ingersoll Rand
Service departments.
This machine has been designed and supplied for use only in the
following specified conditions and applications:
.
Drying water vapor out of compressed air containing no known or
detectable additional gases, vapors or particles
.
Operation within the ambient temperature range specified in the
GENERAL INFORMATION section of this manual.
IF IN DOUBT CONSULT SUPERVISION
.
The company accepts no responsibility for errors in translation of this
manual from the original English version.
SSR ULTRA COOLANT
R
is a registered trademark of
Ingersoll–Rand Company USA.
INTELLISYS
R
is a registered trademark of Ingersoll–Rand
Company USA.

COPYRIGHT 2007
INGERSOLL–RAND COMPANY LIMITED
WARNING
The use of the machine in any of the situation types listed in table
1:
a) Is not approved by Ingersoll Rand,
b) May impair the safety of users and other persons, and
c) May prejudice any claims made against Ingersoll Rand.
TABLE 1
WARNING – NOT PERMITTED
Use of the machine to condition compressed air for:
a) direct human consumption
b) indirect human consumption.
Use of the machine outside the ambient temperature range
specified in the GENERAL INFORMATION SECTION of this
manual.
Use of the machine where there is any actual or foreseeable risk
of hazardous levels of flammable gases or vapors.
THIS MACHINE IS NOT INTENDED AND MUST NOT BE
USED IN POTENTIALLY EXPLOSIVE ATMOSPHERES,
INCLUDING SITUATIONS WHERE FLAMMABLE GASES OR
VAPOURS MAY BE PRESENT.
Use of the machine fitted with non Ingersoll Rand approved
components.
Use of the machine with safety or control components missing or
disabled.
Connection to an electrical supply of incorrect voltage and/or
frequency.
WARNING
The use of repair parts other than those included within the
Ingersoll Rand approved parts list may create hazardous
conditions over which Ingersoll Rand has no control. Therefore
Ingersoll Rand cannot be held responsible for equipment in which
non–approved repair parts are installed.
WARNING
The dryer can contain pressurized air in the shutdown mode. Any
pressurized air must be relieved from the compressor air system
prior to breaching the dryer compressed air side.
NOTICE
The manual is intended for worldwide use and contains both
metric and imperial data where required.