Ingersoll-Rand TS10A, Руководство по эксплуатации и обслуживанию

Страница: 29 / 204

8.0 GENERAL INFORMATION
TS1A–13A
http://air.irco.com
27
8.3 ELECTRICAL SCHEMATIC
Allen – Bradley (A–B) 3–phase Starter Panels
Option
KEY
1AT Thermistor ambient
1DVS Drain valve alarm contact
1FU Control fuse
1M Compressor motor contactor
1MTR Compressor motor
1OL Compressor motor overload
1RPS Compressor discharge pressure switch
1RS Remote sleep mode input
1RTS Compressor discharge temperature switch
1SV Electric drain valve
2AT Thermistor evaporator
2FU Control fuse
2M Fan motor contactor
2MTR Fan motor
2OL Fan motor overload
2RC Fan switch arc suppressor
2RPS Fan pressure switch
2RTS Compressor superheat switch
3FU Control fuse
3RPS Low pressure switch
7FU Heater fuse
8FU Heater fuse
A Alarm
A I/P Analogue inputs
CON Controller
E–STOP Emergency stop
ENLD Electric no–loss drain valve (Option)
GND Ground
I/P Inputs
MPB Main power block
O/P Outputs
P Power
PTC Crank case heater
T1 Transformer, control
TK Fan thermal switch
NOTES
1. Approved fused disconnect or circuit breaker per N.E.C., I.E.C. or
other national requirements must be provided by customer.
2. Dashed lines representing wiring by customer.
3. Sizing of electrical components not supplied by Ingersoll Rand is
the responsibility of the customer and should be done in
accordance with the information on the dryer data plate, N.E.C.,
I.E.C., or other national codes, and local electrical codes.