EN
EN-36
80446339 Rev E
•
PAGES 7-8: ETHERNET SETTINGS
Figure 58 : Ethernet Settings
The following settings are displayed in this section:
IP Address Setting –
When DHCP is not enabled, this setpoint sets the IP
address of the controller.
IP Address Actual –
This will match the IP address setting when DHCP is
not enabled. If DHCP is enabled this will display the address assigned to the
controller by the DHCP server.
Default Gateway Setting –
Setpoint for the default gateway.
Default Gateway Actual –
Current reading/setting for the default gateway.
Subnet Mask Setting –
Setpoint for the subnet mask.
Subnet Mask Actual –
Current reading/setting for the subnet mask.
MAC Address –
This is the unique hardware MAC address for the controller.
This can not be changed.
Enable DHCP –
Allow the controller to automatically receive an IP address
from the Local Area Network (LAN)
Apply –
After editing the desired setpoint navigate to the accept setting and
press enter in order for the values in the setting variables to be confirmed by
the controller.
Cancel –
Discard any changes made to the Ethernet settings.
•
PAGE 9 : OPTION MODULE INFORMATION
Figure 59 : Installed Options
The option module information screen allows the user to see which software
options have been installed in the controller.
An option module that is installed will show up with an “X” in the appropriate
box. The option part number is displayed with the option name.
If no options are installed, this screen will not appear on the controller.
INTEGRAL SEQUENCING FOLDER
•
PAGES 1 THRU 3 : SETUP, TUNING, AND SEQUENCE
Figure 60 : Integral Sequencing Settings
RELEASED 01/Nov/2018 12:06:37 GMT
