Ingersoll-Rand MHP825WCAT, Руководство по эксплуатации и техническому обслуживанию

Страница: 71 / 109

Maintenance Operation & Maintenance Manual
69
Battery
WARNING
!
Always disconnect the battery cables before performing any
maintenance or service.
Keep the battery terminals and cable clamps clean and lightly coated with petroleum jelly to
prevent corrosion.
The retaining clamp should be kept tight enough to prevent the battery from moving.
Pressure System
At 3 month intervals it is necessary to inspect the external surfaces of the system (from the
airend through to the discharge valve(s)) including hoses, tubes, tube fittings and the
separator tank, for visible signs of impact damage, excessive corrosion, abrasion, tightness
and chafing. Any suspect parts should be replaced before the machine is put back into service.
Tire Pressure
See the GENERAL INFORMATION section of this manual.
Running Gear/Wheels
Check the wheel nut torque 20 miles (30 kilometres) after refitting the wheels. Refer to the
TORQUE SETTING TABLE later in this section.
The bolts securing the running gear to the chassis should be checked periodically for tightness
(refer to the
SERVICE/MAINTENANCE CHART for frequency) and re–tightened where
necessary. Refer to the TORQUE SETTING TABLE later in this section.
Lubrication
The engine is initially supplied with engine oil sufficient for a nominal period of operation (for
more information, consult The
Engine Manufacturer’s Manual) .
CAUTION
!
Always check the oil levels before a new machine is put into service.
If, for any reason, the unit has been drained, it must be re–filled with new oil before it is put
into operation.