Ingersoll-Rand HP1300WCU, Руководство по эксплуатации, техническому обслуживанию и каталог запасных частей

Страница: 32 / 75

32
( )
Book 54757919 (5/02)
SECTION 5 -- MAINTENANCE
GENERAL
In addition to periodic inspections, many of the
components in these units require periodic servicing
to provide maximum output and performance.
Servicing may consist of pre--operation and
post--operation procedures to be performed by the
operating or maintenance personnel. The primary
function of preventive maintenance is to prevent
failure, and consequently, the need for repair.
Preventive maintenance is the easiest and the least
expensive type of maintenance. Maintaining your
unit and keeping it clean at all times will facilitate
servicing.
CONTAINMENT BASE
This unit uses a containment base large enough to
hold the fluid contents of the engine oil, coolant, fuel
or compressor oil systems.
Drain plugs are located at strategic positions in this
base to drain accumulated fluids and also to allow
access to system drain plugs in the fuel tanks and
compressor oil resevoir for flushing.
A central drain system is provided for normal service
of engine, fuel, or compressor system.
The containment base should be drained and
flushed monthly or following any fluid discharge into
the base.
SCHEDULED MAINTENANCE
The maintenance schedule is based on normal
operation of the unit. This page can be reproduced
and used as a checklist by the service personnel. In
the event unusual environmental operating
conditions exist, the schedule should be adjusted
accordingly.
COMPRESSOR OIL LEVEL
The oil level is most consistent when the unit is
running unloaded and should be checked at this
time.The oil level should be between the high/low
indicators on the sight glass located on the side of
the receiver tank.
COMPRESSOR OIL
This machine was factory filled with Ingersoll--Rand
Fluid.
By continued use of Ingersoll--Rand compressor
fluids and filters, optional warranty will be extended
for the base airend (rotors, housings, gears and
bearings) when substantiated with proof of
conformance
to recommended maintenance
intervals and purchase of OEM Ingersoll--Rand
filters and fluids.
Optional Warranty -- The earlier of 60 months from
shipment to, or the accumulation of 10,000 hours of
service by the initial user. The optional warranty is
limited to defects in major components (rotors,
housings and bearings), and is automatically
available to the original user when he meets the
following two conditions:
1. Submissions of proof that Ingersoll--Rand fluid,
filters and separators have been used. Refer to the
Operation and Parts manual for the correct fluids,
filters and separator elements required.
2. Submission of proof that maintenance intervals
have been followed.
WARRANTY TIME *BARE AIREND **AIREND COMPONENTS
STANDARD
2 yrs/4000 hrs 100% parts and labor 100% parts and labor