Ingersoll-Rand HP1300WCU, Руководство по эксплуатации, техническому обслуживанию и каталог запасных частей

Страница: 24 / 75

24
( )
Book 54757919 (5/02)
WARNING
Do not climb on top of unit.
LIFTING UNIT
Central Lifting Bail
-- Hoist/crane per machines gross weight
(see general data)
BEFORE TOWING
Ensure that the tires, wheels and running gear are in
good condition and secure.
Wagon Style Running Gear
S
Do not tow this unit in exess of 20 mph (32km/hr).
S
Use a tow vehicle whose towing capacity is greater
than the gross weight of this unit. (see general data).
S
Machine is not designed to be Highway Towable.
S
Set parking brake or chock wheels before
disconnecting from towing vehicle.
S
Optional Parking Brake -- located beside towbar
on front of unit, if equipped.
High Speed Running Gear
S
Use jack to raise or lower lunette eye.
S
Use tow vehicle whose towing capacity is greater
than the gross weight of this unit (see general data).
S
Do not tow this unit in excess of 65 mph.
S
Place wheel chocks under tires before
disconnecting from towing vehicle.
S
When raising or lowering lunette eye, always
stand to one side.
Wheel Chock -- HSRG
-- Located inside of front towbar
-- Secure unit with chocks before disconnecting
drawbar from tow vehicle.
SETTING UP (ALL UNITS )
Place the unit in an open, well--ventilated area. Posi-
tion as level as possible. The design of these units
permits a maximum 15 degree limit on out--of--level
operation.
When the unit is to be operated out--of--level it is im-
portant: (1) to keep the engine crankcase oil level
near the high level mark (with the unit level), and (2)
to have the compressor oil level gauge show no
more than mid--scale (with the unit running at full
load). Do not overfill either the engine crankcase or
the compressor lubricating oil system.
Chock wheels or set parking brake.
This unit is equipped with on--board fuel tanks with
a total capacity of 230 gallons which provides 10
hours of full load operation.
Compressor Mounting
Portable compressors, which are modified to re-
move the running gear and mount the machine di-
rect to trailers, truck beds or frames, etc. may experi-
ence failure of the enclosure, frame, and/or other
components. It is necessary to isolate the compres-
sor package from the carrier base with a flexible
mounting system. Such a system must also prevent
detachment of the package from the carrier base in
the event the isolators fail. Contact Ingersoll--Rand
representative for flexible mounting kits.
Warranty does not cover failures attributable to
mounting of the compressor package to the carrier
base unless it is an Ingersoll--Rand provided sys-
tem.