23
( )
Book 54757919 (5/02)
SECTION 4 -- OPERATING INSTRUCTIONS
3
6
8
7
9
5
12
2
1
\ \
\
\
\ \
\
\
14
15
17
13
11
10
\ \
\ \
4
16
18
Control Panel
f
E STOP
19
20
21
22
23
OPERATING CONTROLS AND INSTRUMENTS
The operating controls and instruments are arranged
on the control panel as shown on previous page. A
description of each panel device is as follows:
1.
Panel Light:
Illuminates PHE instrument and
control panel controlled by Switch 14.
2.
High Compressor Temp
:
Fault indicator
lamp. Indicates shutdown due to high
compressor temperature.
3.
Low Radiator Coolant Level:
Alarm
indicator lamp. Indicates engine coolant
needs service.
4.
Low Engine Oil Pressure
: Fault indicator
lamp. Indicates shutdown due to low engine
oil pressure.
5.
Restricted Air Filter
: Alarm indicator lamp.
Indicates engine/compressor air inlet filters
need service.
6.
High Engine Coolant Temp:
Fault indicator
lamp. Indicates shutdown due to high engine
water temperature.
7.
Restricted IQ Air Filters:
Fault indicator
lamp. Indicates shutdown due to high Pon IQ
air filters (if equipped).
8.
Low Fuel Level:
Fault indicator lamp.
Indicates shutdown due to low fuel level.
Lamp blinks at low fuel warning.
9.
Compressor Malfunction:
Fault indicator
lamp. Indicates shutdown due to compressor
system fault. Refer to Fault Code List.
10.
Low Battery Voltage
: Alarm indicator lamp.
Indicates battery or charging system requires
service.
11.
Engine Malfunction:
Engine Fault code.
Refer to service card or engine manual for
codes and service requirements.
12.
Malfunction Code (4 Digit)
: Compressor or
engine fault. Refer to manual for list of codes
and service requirements.
13.
Ether Inject
: Injects a measured shot of ether
for aid in cold weather starting of engine.
Caution: Use Sparingly.
14.
Panel Light Switch
: Controls panel lamp # 1.
15.
Service Air Switch:
Momentary contact
switch. Allows engine to warm up at low
compressor pressure.
16.
Main Power Control Switch:
ON/OFF Start
Switch.
17.
Heaters:
ON/OFF
Power
Switch
for
regulation and IQ heaters. Prevents freeze up
in cold weather.
18.
Hourmeter:
Indicates machine operating
hours.
19.
E--STOP
: Emergency Stop Push Button (ESA
units only). Push to stop, turn to release.
20.
Discharge Air Pressure Gage:
Indicates
pressure in receiver tank, normally from 0
psi(kPa) to the rated pressure of the machine.
21.
Engine Tachometer:
Indicates engine speed
in RPM from 0 when stopped to full speed.
22.
Systems Gage:
Engine Water Temp
Compressor Oil Temp
Engine Oil Pressure
Battery Voltage
23.
Fuel Level Gage:
Indicate fuel level in tank.
Содержание HP1300WCU
