INGENIA Titan GO, Руководство по эксплуатации продукта

Страница: 6 / 108

TITAN GO Product Manual | Safety Information
INGENIA | 2022-07-14 08:35:14 6
•
•
•
•
•
•
•
•
•
•
•
•
•
3 Safety Information
3.1 About this manual
Read carefully this chapter to raise your awareness of potential risks and hazards when working with the Titan
Servo Drive.
To ensure maximum safety in operating the Titan Servo Drive, it is essential to follow the procedures included in
this guide. This information is provided to protect users and their working area when using the Titan Servo Drive, as
well as other hardware that may be connected to it. Please read this chapter carefully before starting the
installation process.
3.2 Warnings
The following statements should be considered to avoid serious injury to those individuals performing the
procedures and/or damage to the equipment:
The Titan Go has no enclosure and has high voltage live parts . Take precautions before commissioning or
touching it. Direct contact with live parts can cause serious injury or death.
To prevent the formation of electric arcs, as well as dangers to personnel and electrical contacts, never
connect/disconnect the Titan Servo Drive while the power supply is on.
The Titan manages high electrical power and the motors will have high mechanical power. To
prevent damages to the setups or motors, always tune and start testing with low torque and current
limits . Never start a configuration or setup with unlimited current settings.
Disconnect the Titan Servo Drive from all power sources before proceeding with any possible wiring change.
After turning off the power and disconnecting the equipment power source, wait at least 20 seconds before
touching any parts of the controller that are electrically charged or might be hot.
3.3 Precautions
The following statements should be considered to avoid serious injury to those individuals performing the
procedures and/or damage to the equipment:
The Titan Servo Drive components temperature may exceed 150 ºC during operation.
Some components become electrically charged during and after operation.
The power supply connected to this controller should comply with the parameters specified in this
document.
When connecting the Titan Servo Drive to an approved power source, do so through a line that is separate
from any possible dangerous voltages, using the necessary insulation in accordance with safety standards.
High-performance motion control equipment can move rapidly with very high forces. Unexpected motion
may occur especially during product commissioning. Keep clear of any operational machinery and never
touch them while they are working.
Do not make any connections to any internal circuitry. Only connections to designated connectors are
allowed.
All service and maintenance must be performed by qualified personnel.
Before turning on the Titan Servo Drive, check that all safety precautions have been followed, as well as the
installation procedures.