IMET GBS 218, Инструкция по эксплуатации, Страница: 17 / 35

TRADUCTION OF THE ORIGINAL INSTRUCTIONS FOR USE
GBS 218 / AutoCut ED.2010eng rev.00
17/35
It is better to check if blade is well mounted and so: open the carter hinges and remove them from the supports -1/RI0376
by ensuring that the back of the blade is against the pulley -3/RI0377- and it is correctly mounted into the band guides -
2/RI0377-. If necessary untighten the screw of the band tensioner -7/RI0597-a little, place the band better and
reassemble the carter and be sure that safety microswitch -2/RI0376- is rightly pushed by its key.
After switching on the machine, if GREEN light of control box is not flashing, it means that you must tension the band:
It is necessary to screw the screw -7/RI0597- by using the hexagon key until the light flashing and screw again
for 1/4 of tourning.
The procedure to change the blade after a change of pitch, wear and tear, and break is the same one of the above
described procedure. In this case it will be necessary a careful cleaning of all points of connection with the band.
15
– CONTROLS DESCRIPTION
The power sectionalising device are, along the supply cable the plug and socket assembly and the padlockable general
switch
– 1/RI0598- ON THE CONTROL BOX Other devices are showen in below picture –RI0597-:
ADJUSTABLE STOP BLOCKS FOR MITRE CUTS
–12/RI0597-
VICE OPENING HANDLE
–3/RI0597-
WORKPIECE LOCKING HANDLE
–4/RI0597-
BLADE COVER FIXING KNOB
–6/RI0597-
BLADE TENSIONER
–7/RI0597-
CONTROL LEVER HANDLE WITH HOLD TO RUN MICROSWITCH
–8/RI0597-
FRONT SLIDING BAND GUIDE STOP -9/RI0597-
COOLANT TAP -RI0384-
MITRE CUT HANDLE LEVER
–13/RI0597-