IMET GBS 218, Инструкция по эксплуатации, Страница: 16 / 35

TRADUCTION OF THE ORIGINAL INSTRUCTIONS FOR USE
GBS 218 / AutoCut ED.2010eng rev.00
16/35
13.2 - ELECTRICAL CONNECTION

Verify that the voltage and the power frequency are compatible with numbers reported in the technical data plate ( it is
placed on the right side of the floor stand ) a difference over 10 % causes some working unevenness more or less
manifested.
Saw frame of GH models can’t be pulled down without electric supply.
The supply cable has already a CEE plug
. . If you have to replace it with the one of normal use, we suggest you to
let do this operation to specialized persons (for example to electricians).
The phasing performed by the manufacturer allows to get a right rotation of all motors by connecting the wires
in the following order L1=R, L2=S, L3=T, anyway check as follows:
(Band protection carter rightly closed )
a) insert plug into electric wall socket ( and switch on the main switch) the GREEN light that controls 24V line supply,
closed blade carter and blade tension must be flashing.
if this does not happen it is necessary to tension the band according to the instructions of the following
paragraph.
b) turn the motor speed selector on 1 or 2
c) push the button placed inside the handle of the control lever (for GH models turn the mode selector on MANUAL

before the push button)
d) check that band moves; the direction indicated by the arrow printed on the carter -5/RI0377- shows the right
movement.
(if not , after switching off the machine, disconnect the line plug, reverse the connection of two of the connection wire,
excluding green/yellow cable of grounding and start again from point a).
e) be sure that coolant is sucked in by the tank and it arrives in the cutting area, while motor is running and cooks are
opened
–RI0384-
h) stop the working by leaving the handle switch
14 - BAND TENSION
The machine is equipped with a tensioned blade ( and the starting of the motor is impossible if right force of
tension has not been adjusted before) .
After switching on the machine, if GREEN light of control box is not flashing, it means that you must tension the band:It is
necessary to screw the screw -3/RI0385- by using the hexagon key until the light flashing and screw again for 1/4 of
tourning.