IMET GBS 218, Инструкция по эксплуатации, Страница: 14 / 35

TRADUCTION OF THE ORIGINAL INSTRUCTIONS FOR USE
GBS 218 / AutoCut ED.2010eng rev.00
14/35
. Hold to run control system inside the handle of control lever
. Protection from overloads and high temperature thanks to bimetal thermo-protectors placed directly in the blade motor
. Sensor of the blade tension: in case the blade breaks or the tension strength diminishes, the machine stops immediately
. Sensor of the closing of the blade protection: if it opens during the working, the machine stops.
. The stops caused by one of the aforementioned devices needs a complete restoring of the working cycle
-
11.2.2
– PROTECTION AGAINS ACCIDENTAL CONTACTS
. Complete metallic main protection of the blade and the pulleys and the back blade-driving pads
. Forward metallic moving guard, fixed to the forward blade-driving pad. It assures the coverage of the blade in every
position, except for the stretch of blade which makes the cut. Joint to the blade-driving pad, it can be opened only after
the opening of the main protection
. Positioning of the blade close to the bar to cut, thanks to the control lever which is equipped with safety guard against
unintented start-up.
. Clamping vice with rapid clamping action, maximum stroke 7 mm, according to the norms on automatic closing
. Guard extended to both sides which retains the coolant used during the cut, preventing its spilling on the floor
. Parts of the machine with suitably chamfered or rounded angles
.
11 .2.3. LIGHTING OF THE WORKING AREA
An inadequate lighting can cause accidents to the operator, who consequently needs a suited lighting in the working area.
In case of a lack of precise indications (for example, norm ISO 8995) for special areas, we advise to supply a lighting
equal to 750 LUX.
12 - MACHINE DESCRIPTION, E.C. SAFETY NORMS, PROPER USE
Band sawing machine . The head swivels from 0 deg. to 60 deg. left to obtain square or mitre cuts of metal profiles and
solids. The Autocutl make possible autonomous cuts by gravity feed.

It is not suitable to cut wood and assimilated materials (cfr. D.M. 2006/42/CE, enclosure I, paragraph 2.3).
All manual works consist of : locking material, approaching and cutting , tool return, unlocking material and bar
displacement for a new cutting.
The starting of the tool is controlled by the pushbutton inside the handle, which has a safety guard against unintented
start-up.
In designing and manufacturing this machine, we have considered the requirements of the Machine Directive, important
document valid in all E.E.C. Countries. Furthermore we have considered the norms as type A and B in the case that
specifications of type C are not available.
From the working position, in front of the frontal vice, the operator has the possibility to actuate the controls and to control
the good working of the machine.
In the other paragraphs you will find any informations to use the machine in the best way and for a very long time.
1) BASE WITH DOOR
2) ADJUSTABLE STOP BLOCKS FOR MITRE CUTS
3) VICE OPENING HANDLE
4) WORKPIECE LOCKING HANDLE
5) FRONT SLIDING BLADE GUIDE
6) BLADE COVER FIXING KNOB
7) BLADE TENSIONER
8) CONTROL LEVER HANDLE WITH HOLD TO RUN MICROSWITCH INSIDE
9) FRONT SLIDING BAND GUIDE STOP
10) CONTROL CABINET
11) GEAR AND MOTOR
12) ELECTRIC COOLANT PUMP
13) MITRE CUT HANDLE LEVER
14) FLOOR STAND AND BASE CONNECTING SCREW