IMET GBS 218, Инструкция по эксплуатации, Страница: 15 / 35

TRADUCTION OF THE ORIGINAL INSTRUCTIONS FOR USE
GBS 218 / AutoCut ED.2010eng rev.00
15/35
13 - MACHINE SETTING FOR STARTING
Verify that the machine has not clear damages or faults and check upon the standard equipment that includes the tools,
fittings to carry out some adjustments, using and maintenance handbook.
In case the machine is supplied with additional equipment make sure that it is adaptable to the machine.
Point in good time the possible damages or faults to the reseller or to the service staff before start-up the machine.-
Remove the lock flask between saw frame and base.. The protective sustances put on the surfaces to protect the
machine during the moving and transport must be cleaned by a non-filamentous clorth or paper, please check that there
is no rust on the metallic parts.

In case of using compressed air jet always wear proper eye protection.
Remove the possible dirty that can obstruct the passage of the coolant along the coolant hoses.
The parts in motion ( band guides, trolleys, pivots, bearing support, bearing disc etc. ) are already lubricated, the reducer
gear holds the exact quantity of oil necessary to the operation because it is a LONG_LIFE construction type.
13.1 - COOLING SYSTEM
Prepare the cooling by mixing the cutting oil and water ( the tank holds about 15 litres ) in proportion of 1/10, 1/15 or
according to the instructions of the supplier of the product. Pour out some coolant in the tank or directly on the base . In
each case keep attention that cooling does not come out of the base or on the coolant pump motor.