IMET GBS 218, Инструкция по эксплуатации, Страница: 12 / 35

TRADUCTION OF THE ORIGINAL INSTRUCTIONS FOR USE
GBS 218 / AutoCut ED.2010eng rev.00
12/35

11 INSTRUCTIONS FOR USE AND WARNINGS
The machine make square and mitre cuts, it is manually controlled during cutting cicle by the proper handle which has
inside the push button for start or stop the blade motor.
The Autocut models have a special device that, after start push button has been pressed, make possible an autonomous
cutting movement, that automatically stops at the lower cutting point. Blade’s rotation stops also, by a proper microswitch.
Manual return of the saw blade to initial position.

11.1 - This machine is designed and manufactured so as to be safely used by the operator, provided that it is
properly operated . No protections will ever suffice if the operator does not work with due caution, does not make sure
that the machine is in top operating conditions and does not follow the instructions below.
You must remember that the machine is designed to CUT METALS with a sharp tool, and you are responsible to see that
it is operated in a SAFE and CORRECT manner.
You must :
1. make sure that the machine is properly installed and electrical installation is proper.
2. be sure you are familiar with all operating, safety, and applications information before operating this machine.
3. see that all who operate this machine are properly trained and fully aware of all safety practices.
4. not expose yourself or other people to any risk.
5. insist on proper personal protective equipment and practices.
6. maintain all factory installed SAFETY DEVICES and make sure that these are never removed or altered or restricted in
any way.
7. insure that the operator has a safe and orderly work area with adequate light and operating room.
8. be certain that your machinery receives responsible and competent maintenance and that your machinery is inspected
on a regular basis.
9. never mount tools with different features from those for which the machine is designed for.
10.never use this machine to cut workpieces larger than the stated capacity.
11.keep cutting area clear of tools or other loose objects.
12.never operate machine unless all guards are in place.
13.NEVER WEAR loose clothing, long sleeves, large gloves, jewellery, or any other items that may be caught. Confine
long hair.
14.always disconnect power at source when performing maintenance or making adjustments.
15.never insert hands or arms into or near cutting area while machine is running.
16.properly clamp the workpiece in the vice and never hold it with your hands.
17.adequately support stock on both sides of the machine to prevent falling.
It is advisable to install a roller table on the unloading side in case the cutting length of the bar is
bigger than the distance between the blade and the right side of the basement.
18.when cutting very short pieces, make sure they do not jam into the blade.
19.if the blade becomes jammed, turn immediately off the emergency locking button, then replace the cutting unit on
CUTTING START position. If it is not possible open the vice and move the piece check that the blade or the teeth are not
broken, if so replace it.
20 never change the working conditions during the cutting, change them for those precisely indicated only ( for
example speed changing with inverter ESC ).
21.not move the machine while cutting and avoid its instability.
22. wear the personal safety equipment, if required for a safe operation.
ALWAYS OPERATE MACHINE SAFELY,
USING COMMON SENSE AND ALERTNESS .
On some parts of the machine there are some stickers which warn about the safety measures that have to be taken by
the operator who runs it. Their meaning (easy to understand) is indicated in the following chart