IMET GBS 218, Инструкция по эксплуатации, Страница: 10 / 35

TRADUCTION OF THE ORIGINAL INSTRUCTIONS FOR USE
GBS 218 / AutoCut ED.2010eng rev.00
10/35
The packing of the machine is suited to guarantee integrity and protection even during shipments with common means of
transport. Special packings can be supplied in case of particular requests of the user.
These models are provided with a carton packing which allows to store them one above the other (1+1 max.) and to move
them for a short way.
After unpacking , take out the screws lockings between base and panel, and place this one in the working area position.
Remove wood crate from machine base.
The floor stand is supplied dismantled, and it must be fixed to the machine by the screws -at the 4 corners. The front wall
has a door. Use 2 lifting belts putted under the front and the rear of base and place the machine on the floor stand. The
weight is shown on the packing, the weight is also wroten in the technical data of the manual.
Make sure that lifting tools are proper for the weight and that the moving is correctly made without unbalancing the
machine.
DO NOT USE THE MOVABLE ARM WITH THE CONTROL PANEL AS LIFTING UP POINT.
In case of following manipulations, the machine should be displaced with the saw frame completely down and fixed.
.
ADVISE: on Autocut models , if you now lift up the saw frame , it is not possible to move it down without
connect the electric supply to the machine.
9 - FITTINGS / OPTIONALS
The information necessary for the installation are given together with the fittings. Anyway you can find here following a
short description of the product.
Adjustable bar stop - standard device - It is fixed at the right side; it is suitable to make cuts of the same lenght.
RABGBC - Loading mounting bracket, to connect the loading side of the machine to one of these two roller tables:
Loading Roller Table
–RTS230/60C1
- To instal
l them rightly, it is necessary first of all to level the machine’s work
table. To level and line up the loading roller table refer to the work table and to the supporting back jaws. It is 1 meter
long and has 3 rollers 50 mm diameter, 280 mm length. Take as reference point the worktable and the support back
jaw in order to aligne the roller tables starting from the one that is nearest to the machine.
Modular roller tables RTSPRW30 - RTSSEW30
- To install them rightly, it is necessary first of all to le
vel the machine’s
work table. To level and line up the loading roller table refer to the work table and to the supporting back jaws. They are
2 meters long and has 7 rollers 50 mm diameter, 280 mm length. Predisposed to be connected themselves for a
loading line of 4 , 6 meters and more.
Take as reference point the worktable and the support back jaw in order to
aligne the roller tables starting from the one that is nearest to the machine
Minimal lubrication system
–
This device, applied to the saw, allows to eliminate almost completely the traditional
coolant system, keeps the material much cleaner and avoids to waste cutting oil and water. It works only during the cut.
It is comprised of a nozzle - 1/RI0463 - with micro-holes, a tank with devices to adjust the quantity of oil and the air
pressure. The switch of the electric system - working with low tension 24V AC - allows to turn it off at any moment and
use the normal coolant system