ILX Lightwave LDC-3700C Series, Руководство пользователя, Страница: 99 / 176

C O M M A N D R E F E R E N C E
Command Reference
04_09 LDC-3700C Series
83
C H A P T E R
4

The LASer:ENABle:COND command sets the condition status enable register of the
LASER operations for summary (in bit 3 of the status byte) and generation of service
requests.
Parameters An <nrf value> whose sum represents the enabled bits:
Notes The enabled or disabled LASER conditions can be read by using the
LASer:ENABle:COND? query.
The LASER condition status can be monitored by the LASer:COND? query. If any of the
enabled LASER conditions are true, bit 3 of the status byte register will be set.
The enable registers normally retain their values at power-up (as they were at power-
down) unless the power-on status clear flag is set true (for more information see the
*PSC definition, in the IEEE488.2 specification).
Examples "LAS:ENAB:COND 129" -action: enables the LASER status condition register so that the
Open circuit and LASER current limit conditions will be summarized in the status byte
(bit 3).
Laser:Enable:Cond #H0F9B" - action: enables the LASER status condition register so
that any and all of the above conditions will be reported in the status byte register (bit 3).
LASer:ENABle:COND <nrf value> C
OMMON
D
EVICE
D
EPENDENT
F
RONT
P
ANEL
1 - LASER Current Limit 256 - Output is Shorted
2 - LASER Voltage Limit 512 - Output is Outside Tolerance Limit
4 - N/A 1024 - Output On/Off State
8 - Power Limit 2048 - Ready for Calibration Data State
16 - Interlock Disabled 4096 - N/A
32 - N/A 8192 - N/A
64 - N/A 16384 - N/A
128 - Open Circuit 32768 - N/A