ILX Lightwave LDC-3700C Series, Руководство пользователя, Страница: 174 / 176

C A L I B R A T I O N A N D T R O U B L E S H O O T I N G
Troubleshooting
158
LDC-3700C Series
C H A P T E R
5

E-210 <PROGRAM DATA> will not convert to a floating point value.
E-211 <PROGRAM DATA> will not convert to a character value.
E-213 <PROGRAM DATA> is incorrect block data length.
E-214 <PROGRAM DATA> length exceeds maximum.
E-301 A <RESPONSE MESSAGE> was ready, but controller failed to read it. (Query
error).
E-302 Query error. Device was addressed to talk, but controller failed to read all of the
<RESPONSE MESSAGE>.
E-401 TEC (Temp Limit) booster interlock disabled output.
E-402 Sensor open disabled output.
E-403 TEC module open disabled output.
E-404 TEC Current limit disabled output.
E-405 TEC Voltage limit disabled output.
E-407 TEC high temperature limit disabled output.
E-408 Booster change disabled TEC output.
E-409 Sensor change disabled TEC output.
E-410 TEC out of tolerance disabled output.
E-411 TEC control error disabled output.
E-412 Analog section status is all 1's or all 0's (power down).
E-413 Serial EEPROM checksum error.
E-415 Sensor short disabled TEC output.
E-416
E-419
Incorrect Configuration for Calibration Sequence to start.
Setting a measurement is only valid during the calibration phase for that
measurement. User has tried to calibrate a measurement without first entering the
required calibration mode.
E-501 LASER interlock disabled output.
E-503 LASER open circuit disabled output.
E-504
E-505
LASER current limit disabled output.
LASER voltage limit disabled output.
E-507 LASER Power limit disabled output.
E-508 LASER output disabled because of TEC output off condition.
E-509 LASER output disabled because of TEC High Temperature Limit condition.
E-510 LASER out of tolerance disabled output.
E-511 LASER control error disabled output.
E-512 Analog section status is all 1's or all 0's (power down).
E-513 Serial EEPROM checksum error.
E-515 Laser Output must be off to change ranges.
E-516 Incorrect Configuration for Calibration Sequence to start.
Table 5.5 Error Messages
Error Code Explanation