Ikegami MCP-300, Руководство по эксплуатации

Страница: 54 / 86

5. Camera Select
40
5. Camera Select
The camera to be adjusted is selected using the Camera Select switch located at the
bottom of the MCP. It is possible to extend by switching groups.
Note :
Please refer to "2.3. Camera Control Section 2" for the location.
5.1. Program Number Display
Displays the program number of the camera on the Camera No. indicator located just
above the Camera Select switch.
There are three modes for the program number display.
(1) FIX mode (Fixed)
Sets the number display of the MCP only without involving the camera.
(2) CAM mode (Camera priority)
Places the priority on the number assigned to the camera, and the number of
MCP also changes with the number of the camera. If there is no answer from
the camera, the number stored in MCP will be displayed.
(3) MCP mode (MCP priority)
Places the priority on the number stored in the MCP, and the number is sent to
the camera via command. Since the information will be sent only to the group
that is displayed, the number of the camera may be changed depending on the
timing of the camera being switched.
Note :
Please refer to “8.3 Panel Configuration Setting” for mode selection.
Memo:
If the number is 3-digit, the first digit will be omitted to display.
Example: Displays "03" instead of "103".
5.2. Camera Select Settings
The MCP-300 has the capability to be shared by many cameras. Initially the Camera
Select switches are setup sequentially, but the user can customize for any camera system
to be assigned to any select switch by changing the assignment.
Note :
Please refer to “3.8.2 Assign” for changing camera select assignment.
5.3. External Camera Select
Selects remote control of Camera Select of the MCP-300.
The external Camera Select is controlled by input to the EXT-1 connector on the rear of
the MCP. Connect the CAMSEL_ENABLE terminal (pin no. 15) to GND. The external
control is enabled when the EXT SEL switch is illuminated. If the EXT SEL is flashing,
the CAMSEL_ENABLE terminal (pin no. 15) is open.
Note :
For the MCP-300, if the external Camera Select is enabled, the Camera Select
switches of the MCP are also enabled.