IFM Ecomat 300 AC1029, Основное руководство устройства

Страница: 130 / 280

ifm Basic Device Manual AS-i ControllerE M4 Target V15 2015-10-30
Set-up Configuration
130
11.2.3 Manual slave addressing
The old slave address is not 0? The automatic procedure described above (
→ page
127 ), however,
only works without problems if the slaves to be connected have the address 0! If the slaves have
already been used in another system, the slaves probably already have another address. In such a
case, the controllere does not react to the connection of the new slave.
► Remove these slaves from the system.
In the following section we will show you how the addresses of the devices can be changed.
E25 ASi1
Config. Error
► End automatic addressing:
Press [ESC] several times to return to the start screen (
→ figure).
M M E E N N U U
1/2
▲
!
▼
U U S S E E R R
You would like to integrate a slave in the AS-i bus which has already been assigned an address but
now needs a new address?
Prerequisites:

Neither the "old" nor the new address of the slave is allowed on the bus.

Connecting a slave with the address 0 to the AS-i bus is not allowed.
► If necessary, temporarily remove the existing slave with the correct "old" address from the bus.
► Install or activate the new slave on the bus.
NOTE
Password level 1 required
→ page
142 , chapter Password setting
[MENU] > [Address Slave] > [Change Address] > select master > select old slave address > [OK] >
select new slave address > [OK] > [MORE] orr [ESC]
1. E25 ASi1
Config. Error
> The display on the left appears instead of the ifm start screen:
"Config. error"
> LED [CONF/PF] lights
Cause: There is (at least) one new slave on the bus which is not yet in
the projection list of the the controllere.
Note : error description
→ page
239 , chapter Error description
► Press [MENU]
M
M
E
E
N
N
U
U
1/2
▲
!
▼
U
U
S
S
E
E
R
R