iDirect Evolution X1, Инструкция по установке и безопасности

Страница: 34 / 60

22 iDirect Evolution X1 Satellite Router Installation and Safety Manual
Preparing the Coax Cables
Figure 8. Cutting Technique for Removing Foil in the Braid
4 Fold the braid back over the jacket and trim the braid to the length as defined under
Length C in Table 9 on page 21 and shown in Figure 9 .
Figure 9. Folding the Braid
5 Flare the inner, outer braids and the outer foil shield only. Do not flare the inner foil
shield (last foil around dielectric).
6 (If using a coax stripper, skip this step.) Being careful not to cut into the copper of the
center conductor, remove the foil and cut the dielectric to the length shown under
Length B in Table 9 on page 21 . Remove any dielectric residue.
7 If the conductive foil is burred, then smooth out the burr so that the edge (area where the
dielectric material was removed) is smooth and provides a lead-in for the connector
mandrel.
8 Install connector mandrel over foil and underneath the braid.
Note: The white color inner dielectric insulation should be flush with the inner rear
surface of the connector. Refer to the picture on the right in Figure 10 for an
RG-11 termination.
9 Since RG-11 connector has a built-in center pin, ensure that the coax center pin makes
contact to the internal seizing pin of the connector. Refer to
Figure 10 on page 23 .