iDirect Evolution X1, Инструкция по установке и безопасности

Страница: 19 / 60

iDirect Evolution X1 Satellite Router Installation and Safety Manual 7
Physical and Environmental Considerations
• Power Sources
Operate this product only from the type of power source indicated on the bottom of
approved power supplies (100 VAC - 240VAC, 50/60Hz). If you are not sure of the type of
power supply at your site, consult your teleport operator or local power company.
• Power Cord Protection
Route power supply cords so they are not likely to be walked on or pinched by items
placed upon or against them; pay particular attention to cords at plugs, convenience
receptacles, and at the point where they exit the product.
• Overloading
Do not overload wall outlets, extension cords, or integral convenience receptacles as this
can result in a risk of fire or electrical shock.
• Electrical Safety
For electrical safety, power line operated equipment accessories connected to this unit
should bear the UL, NRTL, CE listing mark and should not be modified so as to defeat the
safety features. This helps to avoid any potential hazard from electrical shock or fire. If in
doubt, contact qualified service personnel.
• Water and Moisture
To reduce the risk of fire or electrical shock, do not expose this product to rain or
moisture.
• Lightning
For added protection, unplug this product from the wall outlet (and disconnect the
antenna and cable system) during a lightning storm or when it is left unattended and
unused for long periods. Doing so prevents damage to the product from lightning and
power-line surges.
• Heat
Do not place the IDU near heat sources such as radiators, heat registers, stoves, or other
products (including amplifiers) that produce heat.
• Accessories
To avoid personal injury or damage to the iDirect Evolution X1 Satellite Router, do not
place the chassis on any unstable rack, cart, stand, table, or bracket. Any mounting of
the product should follow the manufacturer’s instructions.
• Attachments
Do not use attachments unless recommended by the manufacturer as they may cause
hazards or damage to equipment.
• Restricted Access
This unit is intended for installation in restricted access areas. A restricted access area is
where access can only be gained by service personnel through the use of a special tool,
lock and key or other means of security, and is controlled by the authority responsible for
the location.
• Grounding
Never defeat the ground conductor or operate the equipment in the absence of a suitably
installed ground conductor. Contact the appropriate electrical inspection authority or an
electrician if you are uncertain that suitable grounding is available.