iDirect Evolution X1, Инструкция по установке и безопасности

Страница: 30 / 60

18 iDirect Evolution X1 Satellite Router Installation and Safety Manual
iDirect Evolution X1 Satellite Router Rear Panel
4.6 iDirect Evolution X1 Satellite Router Rear Panel
This section describes and illustrates the rear panel connectors and LED indicators. They are
shown in
Figure 4 . See Table 7 for a description of each connector and indicator.
Figure 4. iDirect Evolution X1 Satellite Router Rear Interface Connectors
Table 7. iDirect Evolution X1 Satellite Router Connectors
Label Connector Type Interface and Purpose
+24V 2.7A CUI 2.5mm Ex24VDC power supply
TX Out 75 ohm, F-Type L-Band Transmit signal to Block UpConverter
(BUC) capable of 10 MHz Reference and +24 VDC @
1.5 Amps maximum over operating temperature
RX In 75 ohm, F-Type Monitor of the actual receive signal from LNB
Output
Reset Recessed push button Factory default reset
LAN A RJ-45 Category-5 STP or UTP cable, 10/100
Base-T Ethernet LAN port connects the Evolution
X1 Satellite Router to the customer LAN
Hub/switch
Ground 4-40 mounting stud chassis ground